Figure 1
Functional Buttons
LCD Display
Rotary Switch
Clam Jaw
Current Signal
Output Terminal
COM Terminal
Input Selector
Trigger
1
OPERATING INSTRUCTIONS
13 Function True RMS Digital Clamp Meter
DSA2009TRMS
IMPORTANT: RECEIVING INSTRUCTIONS
Visually inspect all components for shipping damage. If you find damage,
notify the carrier at once.
Shipping damage is NOT covered by warranty. The carrier is responsible
for all repair or replacement costs resulting from damage in shipment.
Dual insulation Diode
Grounding Low battery
Warning prompt AC or DC (Alternating current or direct current)
AC (Alternating current) Danger! High voltage!
DC (Direct current) Comply with EU standard
Continuity Test
I. DISPLAY SYMBOLS (See Figure 2)
1 Low Battery
2 Manual Range
3 Auto Range
4 DC
5 Negative Polarity
6 AC
7 True RMS
8 Low Pass Filter
9 DC Current # Clearing
10 Simulation Bar & Graduated Scale
11 Inrush
12 Voltage (Volt, millivolt)
13 Current (Amp)
14 Frequency (Hertz)
15 Resistance (Ω, kΩ, MΩ)
16 Capacitance (nF, uF, mF)
17 Diode
18 Continuity
19 Duty Ratio
20 Data Hold
21 Slave Display
22 Relative Value
23 Minimum Value
24 Maximum Value
25
Auto Shutdown
Read this owners manual thoroughly before use and save.
Input Terminal
Figure 2
1
4
5
6
8
9
11
3
2
18
15
13
14
16
12
17
10
19
2024
23
25
22
21
7
To Next Page
Need help?
General
