spikenzielabs Useless Machine - Resistor Placement and Soldering; Screw Terminal Installation and Soldering

Resistor placement and soldering:
1- Place the resistors in place as
the photo above.
2- Flare the legs
to hold the
resistors in place
3- Solder the 4
legs on the
bottom side of the
PCB.
4- While wearing
safety glasses,
Trim the excess.
Screw terminal placement and soldering:
1- Slide the 2 screw
terminals together joining them
into one single 4 pin strip.
2- The holes in
the screw
terminals need to
be aiming away
from the switch.
3- Solder all 4 pins.