Spimbey 2001 - A-Frame Stakes (Step 6); A-Frame Swings and Plates (Step 7)

Parts Required:
309 Ground Stakes X 4
A-FRAME
6
A-FRAME
7
#12 x 2.00 Pan Head Screw X4
Pre-drill hole using
an 1/8” drill bit x 1.50” deep
Attach stakes to outside of A-frame legs on
side of wood shown.
Hang swings from hanger as shown.
Adjust height using chains.
Attach Logo Plate centered on beam
using 1.00” screws in plate bag
Attach Warning Plate using
1.00” screws in plate bag
40.00”
[101.6]
53.00”
[134.6]
Minimum from
ground
8.00” [54.5]
Minimum from ground
309
4x
1. Attach parts as shown