19/11/2013 Vers. 1.1 14
6. Preparing the Car
To start the procedure, you need to perform some preliminary operations:
Drive the car for a few minutes so as to bring the gearbox oil at its operating temperature
Raise the car using the appropriate lift
Remove any protective casing
Look for the identification plate, by means of which it is possible to identify the type of transmission you are
going to treat.
Figure 16 - Example of a transmission identification plate
Finally, locate on the transmission the delivery and return of the lubricant to the heat exchanger, the cap
related to oil level check (if present) and the lubricant’s drain (if present).
Figure 17 - Delivery and return pipes, level indicator, drain plug
To Next Page
Loading...
