machine. The operation to Phone based remote is similar to operations
on the front panel. The real time setting values will be shown on control
panel. User need to turn on the ball machine first before turn on remote
APP. Power on the machine first and press ENTER button after
putting machine at right position. Then user should select USR-xxx for
wireless access before make remote connections. User can see more
details and download Android installation code from
http://www.spinshot.co.uk/Remote.html , or search for "Drill Maker" in
Apple Store for iphone application code.
The App is free and new user can also download the app and install it
on the phone to try the remote features.
Manual Setting Buttons
PLAY/STOP: The button will trigger the machine to start or stop. Every
time when you press this button to start the machine, the machine will
hold for 10 seconds before it propel the balls. Machine will not take any
setting changes during this time.
UP(+)/DOWN(-): The UP(+)/DOWN(-) button are used to adjust the
manual setting parameters. Before clicking the button, the user needs
to choose the type of setting to be adjusted. The types of setting
include ball SPEED, ball HEIGHT, FEED frequency, SPIN level, h1-h2
and w1-w2. Please find sections below for more details about different
setting types.
RESET: Press RESET button will show version information of
machine.
ENTER: If machine is not in running but at power on Initialization stage,
the ENTER button has to be pressed after the user points the
machine in proper direction. If machine is already in running status
and the user needs to change the ball height, the ENTER button needs
to be pressed after inputting the height value. The machine will not
shoot any balls until the height adjustment is completed.
SPEED: The SPEED button needs to be pressed first when the user
adjusts the ball speed. Then the user can press the UP or DOWN
buttons to adjust the speed level (shown as RATE in LCD screen). Its
value can be shown on LED with maximum level at 20 and minimum
To Next Page
Loading...