level at 1. The SPEED value can be adjusted when the machine is in
running mode and will take effective immediately.
FEED: The FEED button needs to be pressed first when the user
adjusts the ball feed interval. Then the user can press the UP or DOWN
buttons to adjust the feed rate. Its level is shown on LCD with 9 being
fastest (approximately 1 ball every 1 second at the manual setting
mode without oscillation).
SPIN: The SPIN button needs to be pressed first when the user adjusts
the ball SPIN level. Then the user can press the UP or DOWN button to
adjust the amount of spin. It can set topspin or slice levels. When SPIN
is set at 0, it will be flat balls. +9 represents the highest level of topspin
and -9 represents the highest level of slice. The SPIN level can be
adjusted when the machine is in the running mode and will be effective
immediately. (See note-2 for spin level setting at vertical oscillation
modes)
HEIGHT: The HEIGHT button needs to be pressed first when the user
adjusts the ball height level. Then the user can press the UP or DOWN
buttons to adjust the height value. It will control the ball height when the
machine is not running in the vertical oscillation mode. The height level
can be shown on the LCD with highest level at 50 and lowest level at 1.
The user needs to press the ENTER button to make the height
setting take effective if machine is running. After press the ENTER
button, the machine will stop shooting out balls until the height level
adjustment is done.
In the vertical oscillation modes, the user needs to use h1-h2 button to
adjust the height oscillation range. Please see below section for h1-h2
setting.
In the vertical oscillation modes, the HEIGHT button will also be used
but not represent the ball height. The HEIGHT value will show the
number of shoots at each height level (defined by h1, h2).
h1-h2: The button is used only in the vertical oscillation modes. In the
vertical oscillation modes, the machine is shooting balls at 2 height
levels defined by h1 and h2. Pressing once on the h1-h2 button will
give access to set the h1 level with a minimum level at 1 and a maxim
level at 20. Pressing again on the h1-h2 button will give access to set
the h2 level with a minimum level of 30 and a maxim level of 50. This
To Next Page
Loading...