TCOM-SC
..........page12-16
Charging the BluetootPDevice
Before using this device, fully charge the Bluetooth”device.
1.
Insert the USB plug of the charging cable into the small USB jack on the
headset. Insert the other end of the charging cable into the Power Adaptor or
your computer's USB port.
2.
While charging, the “battery” icon is displayed one the screen and will be
flashing.When the battery is fully charged,the “battery”icon will stop flashing.
The charging time is about 4 hours.
Tip: To maintain long life from the internal polymer battery, charge your device at
least once each month.
Powering 0n and Off
1.
To turn the device on, press the Power/lntercom button for 3 seconds until
you hear a beep. The display will show “LOUIS ON”. Then the state of the
battery will be show. When turned on, the TCOM-SC headset automatically
establishes hands-free phone and streaming music connections with the last
connected Bluetooth” devices(phone and/or music device). The “phone
connecting” icon and “CONNECT” will be shown on the display screen.
2.
To turn the device off, press and hold the Power/lntercom button for 5
seconds until you hear “DuDu Di--”. The display screen will show “LOUIS OFF”.
Adjusting the Volume
The TCOM-SC headset has a volume control dial: VOL+ and VOL- (the MFB is
To Next Page