Tips & Troubleshooting
The Bluetooth“
Receiver
has no power.
The headset must be charged for at least 4 hours
prior to first use. Refer to Charging the Bluetooth”
Device on page 8(12) for further details.
My helmet is
uncomfortable to
wear after fitting the
speakers.
The placement of the speakers within the helmet
may require repositioning. Two additional felted
adhesive earphone pads are supplied for this
purpose. Note: Some helmets have removable
padding: if yours does, it is recommended to run the
speaker and microphone under the padding.
My Phone wont pair
with the Bluetooth”
Receiver.
Activate the BIuetootI1’function on your mobile
phone and search for the device, which will show up
as T-COMVB/T-COM on the Device List, Refer to
your phones instructions to do this. Refer to Pairing
to your BIuetooth°EnabIed Mobile Phone on page 8
(13) for further details.
The audio reception
breaks down.
Bluetooth°enabled device are susceptible to
occasional interference from other common devices
such as GPS units, laptops, alarms and WIFI routers
etc. Move away from potential sources of
interference if you are experiencing problems.
I can’t hear my
music/incoming calls.
Check the volume on the attached device. Setting
your phone or MP3 player to the maximum volume
usually resolves this issue.
To Next Page