English | 11
Action Figure Page
Selecting a drill chuck (323, 330, DD 529) 1 69
Removing the Quick Change Chuck (323, 330, DD 529) 2 70
Inserting the Quick Change Chuck (323, 330, DD 529) 3 70
Inserting SDS-plus Drilling Tools 4 71
Removing SDS-plus Drilling Tools 5 71
Selecting the operating mode and rotation direction 6 72
Changing the chisel position 7 73
Changing the position of the auxiliary handle 8 74
Adjusting the drilling depth 9 74
Switching on and off and setting the speed 10 75
Locking-on the On/Off switch 11 76
Releasing the On/Off switch 12 76
The vibration emission level given in this information
sheet has been measured in accordance with a stan-
dardised test given in EN 60745 and may be used to
compare one tool with another. It may be used for a
preliminary assessment of exposure.
The declared vibration emission level represents the
main applications of the tool. However if the tool is used
for different applications, with different accessories or
poorly maintained, the vibration emission may differ.
This may significantly increase the exposure level over
the total working period.
An estimation of the level of exposure to vibration
should also take into account the times when the tool
is switched off or when it is running but not actually
doing the job. This may significantly reduce the expo-
sure level over the total working period.
Identify additional safety measures to protect the ope-
rator from the effects of vibration such as: maintain the
tool and the accessories, keep hands warm, organise
work patterns.
Maintenance and Cleaning
X For safe and proper working, always keep the
machine and ventilation slots clean.
After-sales Service
and Customer Assistance
Our after-sales service responds to your questions
concerning maintenance and repair of your product as
well as spare parts. Exploded views and information
on spare parts can also be found under:
www.spit.com
www.ramset.com.au
www.ramset.co.nz
Our customer service representatives can answer
your questions concerning possible applications and
adjustment of products and accessories.
Disposal
The machine, accessories and packaging should be
sorted for environmental-friendly recycling.
Do not dispose of power tools into household waste!
Only for EC countries:
According the European Guideline
2002/96/EC for Waste Electrical and
Electronic Equipment and its imple-
mentation into national right, power
tools that are no longer usable must
be collected separately and disposed
of in an environmentally correct man-
ner.
Subject to change without notice.
To Next Page
Loading...