18
EFFECTS CAUSES REMEDIES
Malfunctioning of
the charge feed or
percussion device
- Insufficient force on the tool
when resting it on the support
- Hold the tool resting on the support
- The charger disc has not turned - Check the condition of the small bar
- Munition carrier sleeve not sliding
properly
- Disassemble, clean
- Malfunctioning of the charger
disc
- Check it
- No more studs in the magazine - See magazine pin
- Barrel dirty - Disassemble, clean
- Tool too hot - Allow to cool
Barrel jammed at the
back
- Moving assembly (barrel) dirty) - Disassemble, clean
- Tool too hot - Allow to cool
Lack of power or
uctuation in power
- Deterioration of the inertia block - Change it
- Inertia block very eroded - Change it
- Deterioration of the spring - Change it
- Deterioration of the insulation
ring
- Change it
Too much force needed
to rest the tool on the
support
- Barrel dirty - Clean, oil and reassemble
- Presence of foreign matter - Clean, oil and reassemble
Impossible to close the
magazine’s cover
- More than 10 studs in the
magazine
- Remove the studs
- Stud guide not sliding properly - Contact SPIT’s after-sales service
department
Jamming of the inertia
block
- Strip residues stuck - Clean
Poor stud feed - Presence of residues in the
magazine
- Clean
- Stud guide not sliding properly - Contact SPIT’s after-sales service
department
Troubleshooting
P370 BACK PART
Only your SPIT agent or his representative is
authorized to disassemble this assembly.
To Next Page
Loading...
