SPL Phonitor se - Output Specifications

21
Specications
Outputs
Standard headphone output
Warning: Never connect a mono jack cable to the standard headphone output (front panel stereo jack).
Make sure that the stereo jack is fully inserted, otherwise a short circuit might damage the headphone
amplifier!
• . mm TRS connector
• Pin wiring: Tip = Left, ring = right, sleeve = GND
• Source impedance: . ohm
• Damping factor ( ): 
• Frequency range ( - dB):  Hz to  kHz
• Crosstalk ( kHz): - dB
• THD & N ( Hz –  kHz,  dBu): .%
• Noise (A-weighted): - dB
• Output power ( kHz, % THD,  ):  x . W
• Output power ( kHz, % THD,  ):  x  W
• Output power ( kHz, % THD,  ):  x  W
• Dynamic range: . dB
I
F
R
B