15
RV/MARINE WINTERIZATION
IMPORTANT - DO NOT DISCARD
Keep this page with your owners manual for future reference
SPECIAL WINTERIZATION INSTRUCTIONS FOR RV/MARINE INSTALLATIONS:
To Winterize your Clothes Washer Optional Winterization
Instructions
To use your washer again,
WINTERIZE
If you’re currently pumping anti-
freeze through your fresh water
system, you can follow these
steps to winterize your washing
machine:
1. With machine power OFF,
advance cycle selector knob to
“Lightly Soiled”;
2. Press the Power button, then
ensure that the water tempera-
ture setting is set to HOT. Press
and hold START. Let the ma-
chine run for 1 minute and 45
seconds. During this time, the
drum will rotate, then all water
inlet valves will be activated for
a short period, followed by a
brief pause of movement;
3. During the brief pause, press
and hold the Power button to
turn power OFF.
Note: If you have not seen an-
tifreeze entering the machine
(soap dispenser drawer), repeat
Steps 1 & 2;
4. Advance cycle selector knob
to Spin + Drain;
5. Press the Power button, then
press and hold START.
6. After letting antifreeze drain
completely from drum, press
the Power button to turn power
OFF. FINISHED.
Winterization Option
1. With washing machine power
OFF, pour ½ quart of RV-type an-
tifreeze into washer drum;
2. Close door. Select “Spin +
Drain” cycle.;
3. Press the Power button, then
press and hold START. let the
washing machine run for 1 to 2
minutes;
4. Press the Power button to
turn power OFF.
5. Unplug washing machine from
electrical outlet (or disconnect
power);
6. Turn water supply faucets OFF.
Disconnect inlet hoses from fau-
cets;
7. Drain remaining water from
the hoses. FINISHED.
DE-WINTERIZE
1. If applicable, reconnect water
inlet hoses to corresponding
HOT/COLD faucets. Turn faucets
ON.
NOTE: Check water inlet hoses
and pump periodically (see
CLEANING & MAINTENANCE
section);
2. Plug machine into appropria-
te electrical outlet (see ELEC-
TRICAL section) - OR reconnect
power supply;
3. With washing machine power
OFF, pour bleach into both
compartment ‘3’ and the extra
bleach compartment ‘4’ of the
Dispenser Drawer, lling both
to their respective max ll levels.
Do not use thickened or splash-
less bleach as excess suds may
occur.
4. Advance the cycle selector
knob to “ ”.
5. Press the Power button, then
press and hold the Start button.
6. Allow machine to run through
the complete cycle to clean out
any remaining antifreeze.
FINISHED.
To Next Page
Loading...