-6-
1. Standard mounting uses the factory
installed visor clips already located on
the vehicle, in conjunction with the
suction cups or window adhesive
mounts. If you do not have any visor
clips, use the Alternate Mounting
section on the next page
.
2. Locate the two visor clips on the vehicle.
The style may vary from vehicle to vehicle.
Some styles use only one screw each,
while others may have more. Verify that
both visor clips are a minimum of 3” from
the center of the window, and a maximum
of 8” from the center.
3. Loosen (or remove if necessary) both visor
clips enough that one of the forked brackets
can easily slide under each of them.
4. Slide one forked bracket under each visor clip
and tighten the clip such that it securely holds
each bracket in place.
Bend here if
necessary
5. Once the brackets are installed securely under the visor clips or with a suitable
fastener, check to see that the bottom of the light is level front-to-back. If it is
not level, remove the light from the visor clips and carefully bend the forked
brackets as necessary. Reinstall the light and check again for levelness.
Repeat this process until the light is level.
Attach Forked Brackets to Visor Clips
(If you do not have visor clips, or your visor clips will NOT provide a secure mount, or this
method will not work in your vehicle for any other reason, use the alternate method on the
next page.)
Universal Mounting (CONT'D)
To Next Page
Loading...