EasyManua.ls Logo

SPM BIG JUICE - Technical and Electrical Specifications; Water Supply Specifications; Disposal

SPM BIG JUICE
84 pages
Go to English
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Use and installation manual
Issue date: 28
th
Oct 2009 Revision: IMQ Page : 20/84
The device must be stored in a dry place with
temperatures ranging from 0°C to 40 °C. When
in the original packing, no more than 2 devices
should be stacked on top of each and they must
always be kept upright, as shown by the arrows
on the packing.
5. TECHNICAL SPECIFICATIONS
Technical and electrical specifications
All the device’s technical and electrical
specifications are stated on the identification
plate applied to the inside of the device and
shown here. The plate also contains the model’s
serial number, which is composed of the
manufacturer’s device code followed by a
progressive production number and
consequently the week in which it was
produced.
The plate specifies:
Model: XX
n°: XX
Electrical specifications: Volt/ Hz: 230 V /
50 Hz
Max absorption (Watt): 370W
Max. current (Amp): 1.9 Amp
Weight (Kg):42Kg
Climatic class: “N”, in accordance with
standard IEC 60335-2-24
Overall dimensions (Fig. 1):
Height: 790 mm
Width: 360 mm
Depth: 600 mm
Noise emissions
The equivalent weighted continuous sound level
is below 70 dB.
Water supply specifications:
The pressure of the water supplied by the water
mains should be kept between 0.1 MPa and 0.6
MPa (1 bar and 6 bar).
In the event of a breakdown:
In most cases any technical problems can be
overcome with small interventions; we therefore
recommend you read this handbook carefully
before contacting the manufacturer or service
centre.
Disposal
Important
All parts of the packing must be kept out of the
reach of children as they may constitute a
safety/health risk.
Important
Please respect the environment by disposing of
the packing as instructed.
This symbol: means the device cannot be
disposed of as common waste. It must be
handled in compliance with the provisions of
European directive 2002/96/CE (Waste Electrical
and Electronic Devices - WEEE) and the national
legislation derived therefrom to prevent all
possible harm to the environment and creating
health risks.
To dispose of the device correctly, contact the
stockist from which you purchased it or our
after-sales service.

Table of Contents