SPM BIG JUICE - Activating the Jug Function

Use and installation manual
Issue date: 28
th
Oct 2009 Revision: IMQ Page : 29/84
Activating the jug function
Once the device has been set up to dispense
individual drinks (see section above), it can then
be set to dispense a jug of the same drinks by
proceeding as follows:
- remove the container (Fig 12);
- set internal switch 4 to "1" to activate the jug
option;
- press button L1 or L2 depending on the drink
of your choice;
- the device will now begin a continuous series
of dispensing operations until the jug is filled.
- The amount of drink dispensed for the jug
option depends on the cup settings as the jug
option is the equivalent of five cups. Therefore if
the cup setting is 200 ml, 1 litre will be
dispensed with the jug option.
- However, the cycle started can be stopped
midway by re-pressing the button just pressed.
In this case the device will finish the current
dispensing operation and then stop (Fig. 10 and
Fig. 11).
Fig. 12