Data di emissione: Settembre, 2016 Revisione: 1 Pag. : 28/44
9. START-UP PROCEDURES
!IMPORTANT!
BEFORE STARTING THE MACHINE, CARRY OUT
THE CLEANING AND SANITISING PROCEDURES
DESCRIBED IN CHAPTER 11.
- Dilute and mix the product in a separate
container according to the manufacturer’s
instructions (see fig.5); never pour dry powder,
crystals, or concentrate into a dry bowl.
Caution
Make sure that the mixture has a sugar content
near the 14%; a lower concentration could
seriously damage the mixing parts, as well as
the gearmotors.
NEVER USE ONLY WATER.
- Remove the luminous cover after unblocking it
by turning its special key clockwise (see fig.6).
- Remove the secondary transparent cover
(fig.7).
- Pour the mix obtained into the bowl respecting
the maximum limit on the bowl (see fig.8).
- Restore the secondary transparent cover and
then the luminous one making sure to have it
pushing against the security system
- Secure it by rotating its key counter clockwise.
Note -----------------------------------------------
IPRO is equipped with a very efficient safety
mechanism designed to protect the operator; it
is activated when cover is lifted. This device
automatically and immediately stops all moving
parts.
If the main cover is not correctly
positioned, the unit will not work.
------------------------------------------------------
- Insert the plug into the electrical power outlet.
- Activate the main switch.
Fig. 5
Fig. 6
Fig. 7
Fig. 8
To Next Page
Loading...
