Data di emissione: Settembre, 2016 Revisione: 1 Pag. : 30/44
a) To dispense the product, position the cup
under the tap and pull the dispensing lever (see
figure 9).
b) Adjusting the consistency: to alter the
consistency of the product, turn the screws
located on the back of the machine in the
following way: clockwise to make the product
less dense, counter clockwise to make the
product denser (see figure 10).
Important
This device only changes the consistency of the
product to be dispensed. It does not affect the
cooling temperature of the product.
Caution
When the level of the slush inside the bowl is
below the minimum, to prevent the product
from becoming too thick, it is necessary to refill
the bowl.
Fig. 9
Fig. 10
To Next Page
Loading...
