Data di emissione: Dicembre, 2018 Revisione: 1 Pag. : 34/80
Automatic mode
Pushing the AUTO button the unit will start
working in the automatic mode with the set
parameters; this mean that the unit will
automatically switch from the freezing mode to
the chilling one respecting day by day the set
parameters.
During this phase the FREEZE and the CHILL
buttons will be visible but not functioning.
!Important!
Defrost or wash modes are not to be used in
lieu of proper cleaning or sanitization
procedures at the frequency of federal, state or
local regulatory agencies.
Setting mode
In order to activate the setting mode it is
necessary to put the finger on the ON/OFF
button for 6/7 seconds; an acoustic signal will
advise the user about the setting procedure
activation.
Now the display looks like the one below and
this is the buttons description:
INCREASE: increases the set parameter.
DECREASE: decreases the set parameter.
ENTER: this button confirms the set parameter.
DAY+: this button allows to slide the day of the
week in order to select the right one.
12H/24H: allows to select the preferred mode.
START/STOP: allows to switch from the freezing
mode time begin to the stop one.
EXIT: allows to exit from the setting mode.
To Next Page
Loading...
