HACK ATTACK™ BASEBALL PITCHING MACHINE
SPORTS ATTACK, LLC. • 800-717-4251 • sportsattack.com
8
Baseball Fungo (Fielding Practice)
BASEBALL FUNGO (FIELDING PRACTICE)
1. Roll Hack Attack to home plate and face toward center field. Install legs, tilt it into
position and connect to electric power.
2. Turn the elevation control counter-clockwise to release the travel lock.
3. Loosen the horizontal swivel lock until the throwing head pivots freely.
By using the handle on the end of the ball chute, you can easily pivot Hack Attack
to aim at any point on the field.
You can simulate various line drives (slicing, fading, sinking, rising, etc.) by adjusting the
spin. Refer to Figure 5 on page 7.
See Figure 6 below:
For pop-ups, push the handle down. Using the opposite hand, situate ball on ball
chute and give the ball a shove hard enough that ball rolls up the chute and into the
throwing wheels.
4. When defensive work is completed, center the throwing head on the undercarriage and
securely tighten the horizontal swivel lock.
5. Secure the throwing head with the travel lock. Allow all three throwing wheels to come
to a complete stop before transporting Hack Attack.
Figure 6 Feeding the ball for pop-ups
WARNING
HAZARD FROM
HIGH-SPEED PROJECTILES
Being struck by a pitched ball can
cause serious injury or death. Make
sure that no one steps in front of
Hack Attack while it is connected to
electric power.
Clear all hitters away from home
plate, the batter’s box and the
backstop area before connecting
Hack Attack to electric power.
CAUTION
PERSONAL INJURY HAZARD
Never reach up chute to push ball
into the throwing wheels. Be sure
to keep hands and fingers well
away from the throwing wheels.
•
Be careful to keep all persons away
from front of Hack Attack any time
it is connected to electrical power.
To Next Page
Loading...
