Sports Attack JUNIOR HACK ATTACK SOFTBALL - Page 9

JUNIOR HACK ATTACK
™
SOFTBALL PITCHING MACHINE
SPORTS ATTACK, LLC. • 800.717.4251 • sportsattack.com
7
Softball Batting Practice
BATTING PRACTICE (cont’d)
SELECTING THE PITCH
NOTE: Vertical (Elevation) and horizontal (swivel) must both be adjusted whenever you
change speed or spin.
Always have the batter step away from the batter box before adjusting speed or spin.
BALL SELECTION
1. Never mix leather balls with synthetic pitching machine balls.
2. Be careful not to mix new with old balls, or balls from different manufacturers.
3. Balls must be consistent in type and amount of wear to produce repeatability.
4. NEVER USE WET BALLS!
Leather balls work well but will wear faster than synthetic pitching machine balls. Watch
to see that leather balls do not begin to soften from the great amount of hitting they
will receive.
Discard old or soft leather balls from your Junior Hack Attack batting sessions. Similarly,
discard older worn synthetic pitching balls.
Figure 5 Pitch Selection Chart - These settings are provided as
general guidelines. Adjustments for players of varying skill can
be made from these settings.
WARNING
PERSONAL INJURY
HAZARD
Never reach down near throwing
wheels for any reason! Always
turn all three speed control
dials to “0”, turn the on/off switch
“OFF”, unplug Junior Hack Attack
from the power source and wait
until the throwing wheels have
come to a complete stop before
reachinghandsorngers
anywhere near throwing wheels.
•
Never loosen the horizontal
swivel lock while pitching to a
batter.
If the lock is not secure, the
throwing head is free to pivot.
A loose swivel lock can allow a
pitch to be inside which could
hit the batter.
Right wheel
speed control
Left wheel
speed control
Bottom wheel
speed control