JUNIOR HACK ATTACK
™
SOFTBALL PITCHING MACHINE
SPORTS ATTACK, LLC. • 800.717.4251 • sportsattack.com
8
Softball Fungo (Fielding Practice)
SOFTBALL FUNGO (FIELDING PRACTICE)
THROWING GROUNDERS, FLY BALLS, LINE DRIVES
AND POP-UPS
1. RollJuniorHackAttacktohomeplateandfacetowardcentereld.Installlegs,tiltit
into position and connect to electric power (See Baseball Set-up & Preparation on
Page 5).
2. Turn the elevation control counter-clockwise to release the frame lock.
See page 5, Photo C.
3. Loosen the horizontal swivel lock until the throwing head pivots freely.
See Photo C.
By using the handle on the end of the ball chute, you can easily pivot Junior Hack
Attacktoaimatanypointontheeld.
You can simulate various line drives (slicing, fading, sinking, rising, etc.) by adjusting
the spin. Refer to Figure 5 on page 7.
See Figure 6 below:
For pop-ups, push the handle down. Using the opposite hand, situate ball on ball
chute so that the ball rolls down the chute and through the throwing wheels.
4. When defensive work is completed, position the “through hole” directly over the
undercarriage nut. Screw in the horizontal swivel lock through the “through hole” and
into the undercarriage nut and tighten securely.
5. Secure the throwing head with the frame lock. Allow all three throwing wheels to come
to a complete stop before transporting Junior Hack Attack.
Figure 6 Feeding the ball for pop-ups.
WARNING
HAZARD FROM
HIGH-SPEED
PROJECTILES
Being struck by a pitched ball
can cause serious injury or death.
Make sure that no one steps in
front of Junior Hack Attack while
it is connected to electric power.
Clear all hitters away from home
plate, the batter’s box and the
backstop area before connecting
machine to electric power.
CAUTION
PERSONAL INJURY
HAZARD
Never reach up chute to push
ball into the throwing wheels.
Be sure to keep hands and
ngerswellawayfromthe
throwing wheels.
•
Be careful to keep all persons
away from front of Junior Hack
Attack any time it is connected
to electrical power.
Photo C Horizontal swivel lock.