Sports Attack JUNIOR HACK ATTACK - Conversion Kits and Procedures; Softball to Baseball and 7.5 Ball Conversion

JUNIOR HACK ATTACK
™
SOFTBALL PITCHING MACHINE
SPORTS ATTACK, LLC. • 800-717-4251 • sportsattack.com
16
CONVERSION
SOFTBALL TO BASEBALL
1. Turn the on/off switch “OFF” and unplug the power cord.
2. Remove three (3) bolts holding softball feed chute.
3. Remove four (4) bolts holding bottom motor to main casting (See Photo G).
4. Reposition motor from bolt holes marked 12” to bolt holes marked 9”
(See Photos G and H).
5. Install four (4) bolts to secure motor to main casting (See Photo G and H).
6. Repeat steps 3 thru 5 for both the left and right motors.
Baseball conversion kit includes (See Photo E):
(3) JHA-2BB Baseball Legs
(1) JHA-38 Baseball Feed Chute
(1) Dial Settings and MPH Softball Label
7. Install baseball feed chute (Reuse the three bolts that held the softball chute to secure
baseball chute to casting).
8. Install new Dial Settings and MPH label over the existing label.
9. Remove three (3) softball legs.
10. Install three (3) baseball legs.
SOFTBALL TO 7.5 BALL
1. Turn the on/off switch “OFF” and unplug the power cord.
2. Remove three (3) bolts holding softball feed chute. Install 7.5 chute (See Photo F).
3. Loosen four (4) bolts (do not remove) on left and right motors. Do not touch
bottom motor.
4. Slide the two top wheels closer together to 7.5 setting (See Photo I).
5. Tighten bolts to left and right motors.
Conversion Kit includes one chute (See Photo F).
Conversion
3 Legs
1 Baseball
Ball Chute
9”
12”
Photo G Bolts on main casting Photo H Main casting and bolt holes Photo I 7.5 setting
Photo E Baseball Conversion Kit
Photo F 7.5 Ball Chute
1 Baseball
Label