JUNIOR H ACK ATTACK
™
BASEBALL PITCHING MACHINE
SPORTS ATTACK, LLC. • 800-717-4251 • sportsattack.com
2
Junior Hack Attack Safety Instructions
SAFETY INSTRUCTIONS
ELECTRICAL SAFETY
Use a 115 volt single phase 3-wire grounded power source.
Up to 200 ft. from power source, use a minimum #14/3 grounded 3-wire extension cord.
Over 200 ft. from power source, consult a licensed electrician for required power cord size.
OPERATING SAFETY
CAUTION: Never reach down near moving throwing wheels for any reason! If it is
necessary to reach into the throwing wheels, ALWAYS :
1. Turn all three speed dials to “0.”
2. Turn on/off switch “OFF.”
3. Unplug Junior Hack Attack from power source
4. Wait until the throwing wheels have come to a complete stop before reaching hands or
fingers anywhere near the throwing wheels.
CAUTION: Carefully check Junior Hack Attack for completeness and condition before
connecting to electrical power:
1. Throwing wheels must be tight on the motor shafts
2. Wheel guard and ball chute must be tightly fastened to the throwing head.
Carefully check the throwing wheels frequently for cleanliness, chips and cracks. Do not use
the machine if the throwing wheels are damaged, or if chips or cracks appear in the wheels.
(For damage within warranty period, see warranty statement, page xi.)
ALWAYS set the speed controls to “0” before connecting the machine to power. Check that
the speed controls are at zero before turning the on/off switch “ON.”
Do not allow anyone to walk in front of the machine if it is connected to electrical power.
CAUTION: DO NOT plug in or energize this equipment untill all Assembly Instructions and
Operation Instructions are read and followed.
WARNING
PERSONAL INJURY HAZARD
Carefully read all instructions in
this manual, and all labels and
warnings on Junior Hack Attack
before using this machine.
Use machine only under adult
supervision. Failure to operate
Junior Hack Attack as described in
this manual can result in severe
personal injury or death.
•
Never loosen the horizontal swivel
lock while pitching to a batter. If
the lock is not secure, the throwing
head could pivot.
A loose swivel lock can allow a
pitch to be inside which could hit
the batter.
ELECTRICAL SHOCK HAZARD
Junior Hack Attack must be
connected to a properly grounded
electrical receptacle.
•
Do not operate on wet ground.
CAUTION
PERSONAL INJURY HAZARD
Keep hands away from throwing
wheels anytime the machine is
connected to a power source.
•
Carefully check Junior Hack Attack
for completeness and condition
before connecting to electrical
power.
EQUIPMENT ELECTRICAL
DAMAGE
Keep hands away from throwing
wheels anytime the machine is
connected to a power source.
•
Carefully check Junior Hack Attack
for completeness and condition
before connecting to electrical
power.
To Next Page
Loading...