37
BELT ADJUSTMENT
The running belt is pre-adjusted to the running deck at the factory, but after prolonged use it can stretch and require
readjustment. To adjust the belt, turn on the main power switch of the treadmill and let the belt run at a speed of 8-10
KPH. Use the Allen Wrench provided to turn the rear roller adjustment bolts in order to centre the belt. If the running
belt is shifting to the left, turn the left adjustment bolt 1/4 turn clockwise, and the running belt should start to correct
itself.
If the running belt is shifting to the right, then turn the right adjustment bolt 1/4 turn clockwise, and the belt should
start to correct itself. Keep turning the adjustment bolts until the running belt is properly centered.
If the running belt is slipping during use, turn off and unplug the treadmill. Using the Allen Wrench provided, turn
both left and right rear roller adjustment bolts 1/4 turn clockwise, then turn the main power switch back on and run
the treadmill at a speed of 8-10 KPH. Run on to the running belt to determine if the belt is still slipping. Repeat this
procedure until the belt no longer slips.
Tool
Tool
Tool
Allen Wrench
Allen Wrench
Allen Wrench
To Next Page
Loading...
