EasyManua.ls Logo

SPOT GEN3 - Page 18

SPOT GEN3
19 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
17
IE Not to be Marketed in the Republic of Ireland
RF Exposure: Per EN 62479:2010, the SPOT Gen4 spectral power density at a distance of 0.1 cm is
calculated to be 3.33 mW/cm² , which is less than the maximum allowable limit for uncontrolled exposure (
8.05 mW/cm²). If concerned about RF exposure during use, place the SPOT Gen4 anywhere it is not directly
touching your body aer functions have been activated. e RF exposure level drops off dramatically with
distance from the SPOT Gen4.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
is Class B digital apparatus complies with Canadian ICES-003.
is device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.
is device complies with FCC Part 25.213.
is device automatically adjusts its transmission frequency according to its location and is compliant with
international regulatory requirements.
e SPOT Gen4 has been so constructed that the product complies with the requirement of Article 10(2)
as it can be operated in at least one Member State as examined and the product is compliant with Article
10(10) as it has no restrictions on putting into service in all of the EU except Ireland. e SPOT Gen4 cannot
be marketed in Ireland.

Other manuals for SPOT GEN3

Related product manuals