Spotlight Combi 05 PC - Electrical Connections; Installation

Combi 05-12-25
DESCRIPTION OF THE LUMINAIRE
Please refer to the pictures on page 2:
① Suspension yoke
② Accessory guides
③ Safety screen
④ Accessory locking spring
⑤ Handle for tilt regulation
⑥ Lamp lid opening knob
⑦ Carriage with lamp socket
⑧ Retaining spring for lamp holder pan
⑨ Lamp position adjustment knob
⑩ Handle for moving luminaire and for safety cable
anchorage
INTRODUCTION
The luminaire you have bought complies to 2006/95/EC,
2004/108/EC and 2011/65/EU European Directives.
The label on the side of the luminaire lists the following
information:
sMODEL
sMAINSSUPPLYVOLTAGE6
sLAMPWATTAGE7
sPROTECTIONINDEX)0
sMAXIMUMALLOWEDAMBIENTTEMPERATUREINª#
sMAXIMUMTEMPERATUREOFTHEBODYINª#
sMINIMUMDISTANCEFROMmAMMABLESURFACE
sINFORMATIONTOlNDTHEPOSITIONªOFTHELUMINAIRE
when the tip of the arrow points upwards
sMAXIMUMTILTANGLERANGE4HESELIMITSIMPOSEDBY
THELAMPMANUFACTURERSHOULDNOTBEEXCEEDEDAS
they would reduce the luminaire’s useful life or lead
to its deterioration.
INSTALLATION
sThe luminaire can be either suspended or mounted on
a stand.
s$ONOTINSTALLTHELUMINAIRECLOSETOORINCONTACT
WITHmAMMABLESURFACES
s4HEMINIMUMDISTANCEATWHICHTHELUMINAIREMUST
BEKEPTFROMEASILYINmAMMABLESURFACESISINDICATED
on the label.
sThe safety norms estimate that a metal wire
screen be mounted on the front of the luminaire to
prevent any large glass fragments from falling if the
projector breaks.
s2EMEMBERTOCONNECTTHESAFETYCABLEIFREQUIREDBY
local health and safety regulations
ACCESSORIES: the accessories estimated for this projector
are listed in the products catalogue and can be mounted
by inserting them in the relevant guides ② so that the
retaining spring is released ④.
#OLOURCHANGERSANDLENSmAPSMUSTBEBONDBYTHE
safety cable to the luminaire.
ELECTRICAL CONNECTIONS
The luminaire is designed to operate with a 220V to
240V supply, 50-60Hz.
The power cable conforms to CEI regulations 20-22.
Before and during the installation, make sure you follow
the guidelines below:
s!LWAYSCHECKTHEEARTHWIRINGFORTHELINEBEINGUSED
s%NSURETHEVOLTAGEFORTHEUNITISTHESAMEASTHEONE
used for the supply
s!LLUNITSAREDESIGNEDFORINDOORUSEIFTHEYHAVE
to be used outdoors, ensure they are protected from
dampness and rain.
s$ONOTUSELAMPSWHICHAREDIFFERENTFROMTHEONES
listed in the lamp table
s4HEREARENOFUSESINSIDETHEUNITSIFITISNECESSARY
they should be installed in the mains
s4HISMODELcan be connected to a dimmer.
WARNING: replace immediately the lamp
when visibly damaged.
WARNING: The luminaires must always be
earthed
5