2
CONTENTS
WARNINGS & PRECAUTIONS ................................................................................ 2
INTRODUCTION .................................................................................................... 2
INSTALLATION ...................................................................................................... 3
OPERATION .......................................................................................................... 4
MAINTENANCE ..................................................................................................... 7
TROUBLESHOOTING ............................................................................................. 8
DECLARATION OF CONFORMITY ........................................................................ 11
WARNINGS & PRECAUTIONS
Using the AA(B)10000AUH-03-Z1 PulsaJet
®
nozzle requires following these safety
guidelines and precautions. Have these instructions available for persons
operating or servicing the equipment.
• Only qualified personnel should install, maintain, and operate the PulsaJet
nozzle. It is the responsibility of the equipment owner to ensure that those
working with the PulsaJet nozzle are trained to safely perform their assigned
tasks.
• US installations shall comply with the relevant requirements of the National
Electrical Code
®
(ANSI/NFPA 70).
• European installations shall comply with the relevant requirements
of EN 60079-14.
• Make sure voltage supply is turned off to the installation before installing or
maintaining the PulsaJet nozzle. Do not disconnect live circuits when working
with flammable materials.
• Provide adequate ventilation to prevent dangerous concentrations of volatile
vapors in spray area.
• Voltage must not be supplied to the PulsaJet 10000AUH-03-Z1 unless it is in
its fully assembled condition.
• Follow all the nozzle specifications during use. Working outside of these
specifications may lead to unsatisfactory spray application, nozzle damage,
damage to equipment, or personal injury.
To Next Page
Loading...
Need help?
General