Spraying Systems PulsaJet 10000AUH-03-Z1 User Manual

7
OPERATION
CHEMICAL COMPATIBILITY:
Be sure the fluids used in the AA(B)10000AUH-03-Z1 are compatible with and will
not cause deterioration of the materials of construction shown in the introduction
to this document.
SAFETY:
• To prevent possible ignition, do not disconnect while energized.
• Make sure all equipment is rated and approved for the environment in which
it is used.
FLUID SUPPLY:
• Make sure maximum pressure rating of 100 psi (7 bar) is not exceeded.
• To help prevent clogging problems, the fluid supply line needs to include a
line strainer.
MAINTENANCE
• All power to the PulsaJet® nozzle must be turned off before any
maintenance is performed on the unit.
• Overspray or other material should not be allowed to build up on the outside
of the PulsaJet nozzle.
• If clogging occurs, the valve components can be removed from the front by
first removing the spray tip and then unscrewing the seat. See Rebuild
Instructions below.

Spraying Systems PulsaJet 10000AUH-03-Z1 Specifications

General

Brand	Spraying Systems
Model	PulsaJet 10000AUH-03-Z1
Category	Paint Sprayer
Language	English