Installing the Softener Electronic Head
This step will require the materials listed below
Questions? Call (800)-589-5592 4
Electronic
Head
Softener
Tank
1) Unscrew the cap on top of
the softener tank.
2) There is a blue cap inside that
also needs to be removed. Both
caps can be discarded.
3) Locate the opening at the
bottom of the electronic head.
4) Align the opening on the
bottom of the tank head with
the pipe inside the tank.
5) Press the tank head down
to allow the threads to
catch.
6) Turn the tank head
clockwise until it is fully
tightened. Hand tight is OK.
Salt-Based Water Softener
To Next Page
Loading...
