66) Prior to turning the water
back onto the system use the
spanner wrench to fully tighten
the pre-filter housing to avoid
any leaks.
64) Add a length of PVC to close
the gap between the
connections.
62) Add a length of PVC to the
elbow to align with the
connection of the CF+ tank.
65) The system connections
should look similar to this upon
completion.
61) Add an elbow pointing
towards the outlet connection on
the CF+ tank.
Questions? Call (800)-589-5592 13
63) Add an elbow to the PVC
pointing towards the outlet on
the CF+ tank.
CF+ System
To Next Page
Loading...
