22|Page
Limited Warranty Statement:
Products manufactured by SpringWell Water Puricaon Systems are warranted to the original
user only to be free of defects in material and workmanship for a period as specied below. This
warranty only applies to the original purchaser and is not transferable.
UV SYSTEMS
Ten (10) year Limited Warranty on the stainless steel reactors, from the date of original
purchase, or installaon (proper documentaon required for vericaon).
ELECTRONICS
Three (3) year Limited Warranty on the ballasts and controllers, from the date of
original purchase, or installaon (proper documentaon required for vericaon).
UV LAMPS, UV SENSORS & QUARTZ SLEEVES
One (1) year Limited Warranty on all ultraviolet lamps, UV sensors and quartz sleeves
from the date of original purchase, or installaon (proper documentaon required for
vericaon).
This SpringWell Ultraviolet Disinfecon System will be repaired or replaced, at our sole opon,
providing that the ultraviolet system or any component is defecve in materials or workmanship
for the periods outlined above and subject to the “Limitaons of Warranty” as outlined below.
SpringWell’s liability under this warranty shall be limited to repairing or replacing the product,
without charge, F.O.B. SpringWell’s closest Distribuon Facility or authorized service depot.
SpringWell will not be liable for any costs of removal, installaon, transportaon, or any other
charges which may arise in connecon with a warranty claim. SpringWell will not be liable for
damage or wear to products caused by abnormal operang condions, accident, abuse, misuse,
unauthorized alteraon or repair, or if the product was not installed in accordance with the
Manufacturers printed installaon and operang instrucons.
LIMITATIONS OF WARRANTY
This warranty does not apply to any of the following:
• Water Quality Parameters lie outside of the following ranges
• Hardness > 120 mg/L (7 gpg)
• Iron > 0.3 mg/L (ppm)
• Manganese > 0.05 mg/L (ppm)
• Tannins > 0.1 mg/L (ppm)
• Turbidity > 1 NTU
• Transmiance (UVT) < 75%
• A product that has been incorrectly installed according to the technical installaon
manual.
• A product that has been modied in any manner, unless approved by the manufacturer.
• A product where the serial number has been altered defaced or removed.
• Damage caused by the use of parts that are not compable, suitable and/or authorized
by SpringWell for use with the product (e.g. non-original lamps or sleeves).
• Damage caused during shipment of the product.
• Water damage is found inside ballast housing or controllers.
• Product is installed outdoors in direct contact with the environment (rain).
• Product is installed in freezing temperatures.
• Product is used in condions that exceed SpringWell’s specicaons.