What to do if SpringWell Accessories has low UV intensity?
If you are experiencing low UV intensity with your SpringWell Accessories, you should remove and clean the quartz sleeve and sensor. Also, verify that your water quality meets the requirements. If necessary, add filtration. If the issue persists, replace the lamp.
How to reset the lamp protection circuit in SpringWell SPRW-UV4-2?
If the system detects a problem with the SpringWell Accessories lamp, try resetting the lamp protection circuit by unplugging the unit for 10 seconds. If the issue continues, replace the lamp with the correct part, which can be found on the silver label on the reactor or on the Maintenance parts screen.
What to do if the UV sensor is not communicating with the SpringWell SPRW-UV4-2 system?
If the UV sensor isn't communicating with your SpringWell Accessories system, ensure all modules are properly connected to the system and each other. Test modules individually by plugging them in one at a time and cycling power to the system. Replace any module that isn't detected when plugged directly into the controller.
What to do if the module is no longer communicating with the SpringWell SPRW-UV4-2 Accessories system?
If a module stops communicating with the SpringWell Accessories system, make sure all modules are correctly connected to the system and to each other. You can test each module by plugging them in one at a time and restarting the system. Replace any module that the controller doesn't detect when plugged in directly.
What to do if SpringWell Accessories has a missing or incorrect lamp key?
If you encounter a missing or incorrect lamp key with your SpringWell Accessories, ensure the lamp key (found packed with the lamp, on the connector) is installed. Unplug and reinstall the key. Verify the key part number matches the lamp on the Maintenance Parts screen.
Lamp key not found
Lists tools and materials needed for UV system installation.
Tri-colour LED and 4-digit display indicate system status and lamp life.
Full colour LCD screen for performance, faults, and diagnostics.
Controller displays diagnostic start-up sequence on colour LCD.
Lists conditions under which the warranty is voided or does not apply.
Process for registering the UV system for warranty and product updates.
General| Type | UV Water Purification System |
|---|---|
| Dimensions | 22.5 x 8.5 x 8.5 inches |
| Flow Rate | 15 GPM |
| UV Lamp Power | 55W |
| Voltage | 110-120V AC |
| Power Supply | 110-120V AC |
To Next Page
