What to do if SpringWell SPRW-UV5-15 has low UV intensity?
If you are experiencing low UV intensity with your SpringWell Accessories, you should remove and clean the quartz sleeve and sensor. Also, verify that your water quality meets the requirements. If necessary, add filtration. If the issue persists, replace the lamp.
How to reset the lamp protection circuit in SpringWell SPRW-UV5-15?
If the system detects a problem with the SpringWell Accessories lamp, try resetting the lamp protection circuit by unplugging the unit for 10 seconds. If the issue continues, replace the lamp with the correct part, which can be found on the silver label on the reactor or on the Maintenance parts screen.
What to do if the UV sensor is not communicating with the SpringWell Accessories system?
If the UV sensor isn't communicating with your SpringWell Accessories system, ensure all modules are properly connected to the system and each other. Test modules individually by plugging them in one at a time and cycling power to the system. Replace any module that isn't detected when plugged directly into the controller.
What to do if the module is no longer communicating with the SpringWell SPRW-UV5-15 system?
If a module stops communicating with the SpringWell Accessories system, make sure all modules are correctly connected to the system and to each other. You can test each module by plugging them in one at a time and restarting the system. Replace any module that the controller doesn't detect when plugged in directly.
What to do if SpringWell SPRW-UV5-15 has a missing or incorrect lamp key?
If you encounter a missing or incorrect lamp key with your SpringWell Accessories, ensure the lamp key (found packed with the lamp, on the connector) is installed. Unplug and reinstall the key. Verify the key part number matches the lamp on the Maintenance Parts screen.
Covers warnings about UV light exposure, electrical hazards, and proper system usage.
Lists the tools and materials necessary for installing the UV system.
Diagram illustrating recommended space for safe removal of lamp and sleeve.
Visual guide for installing a by-pass assembly for easier maintenance.
Procedure for cleaning the UV sensor to maintain performance.
Description of the LED indicators and display for UV4 controllers.
Details on the LCD screen and expandability port for UV5/UV6 controllers.
Explanation of the controller's diagnostic start-up sequence.
Details hard alarms, their causes, and corresponding resolutions.
Details conditions and parameters that void the product warranty.
General| Brand | SpringWell |
|---|---|
| Model | SPRW-UV5-15 |
| Category | Accessories |
| Language | English |
To Next Page
