SpringWell SPRW-UV4-2 - Expansion Modules

19|Page
Expansion Modules
Controllers incorporate an “Innite Expandability Port” (IEP)
which allows for expansion to the UV sensor and all other
modules. Each module (including the sensor) comes with
both a male and female connecon. Connect any device to
the controller and all subsequent devices are then connected
into the female end of last device added in a “daisy chain”
conguraon.
The following oponal expansion modules are available for use on UV5 & UV6 UV controllers.
Contact your authorized distributor for purchasing informaon.
REMOTE ALARM CONNECTION MODULE: Allows for a
connecon to a remote device such as a buzzer, light, alarm
system, PLC, etc., via a pair of contacts. In normal operaon
the OK and COM contacts will be connected, and in a fault
condion (Low UV, Lamp fail, Power Fail), the Fault and COM
contacts will be connected. Maximum contact rang is 30V / 1A
(use 16-22 AWG). Order PN SPRW-MOD-RAM.
SOLENOID CONNECTION MODULE: Connects a NORMALLY
CLOSED line voltage solenoid valve to the controller. Maximum
contact rang is 240VAC (50-60Hz) / 30VDC / 2A. On a non-
monitored system, the solenoid will only close on a lamp failure
error. On a monitored system, the solenoid is closed when
the UV level drops below 50%. Also note that in cases where
emergency use of untreated water is required, the controller
can be placed into a manual override mode allowing for the
ow of water in an alarm condion. Order PN SPRW-MOD-
SOL1.
4-20 mA MODULE: Outputs a 4-20mA signal of the UV output
to a remote device such as a data logger or computer. Order PN
SPRW-MOD-420.
The WiFi module and accompanying IoT applicaon allows you
to connect your UV system to a smart phone, tablet, computer
or other connected plaorm. View system status, receive SMS
or email messages of alarm condions and monitor the health
of your UV from anywhere via this connected plaorm. Connect
the device via the APP found on Google Play or the APP Store
and connect your UV device to your router, then download the
soware for your connected device. Order PN MOD-APP.
The Ultrasonic Flow Meter enables your UV system to dim
power in mes of low to no ow, saving you money on energy,
reducing water temperature, and decreasing the risk of fouling.