30 Section 3B: Troubleshooting
Troubleshooting
䢇 My Power LED is not Illuminating.
䡲 Make sure that one end of the power cord is
securely connected to an active outlet and that the
other end is properly connected to the power
adapter.
䡲 Make sure the power connector is securely inserted
into the rear DC 5V port on the back of the base
station.
䡲 Make sure the Power switch is in the On position.
䢇 My GPS LED is not illuminating blue even after a few minutes.
䡲 The internal antenna is either unable to obtain or
having difficulty obtaining a GPS signal.
䡲 Move the base station to a location with fewer
surrounding obstructions. The new location should
be in a more open area and closer to a window, if
possible.
䡲 If relocation does not resolve the issue, connect the
external GPS antenna to the rear of the base station.
See “Connecting the GPS Antenna” on page 26.
䡲 Make sure the power adapter is properly configured
and securely connected to the rear of the base
station.
䡲 Make sure the Power switch is in the On position. If
the Power LED is not lit, refer to the first
troubleshooting tip for more details.
Note:
The first time the base station is used after installation or
after relocation, it could take up to an hour to acquire a GPS
fix. This is normal.
To Next Page
