(A) Pre-use product cleaning
As to a new appliance, it’s recommended to clean the water system, prior to initial use.
1) Take out the appliance, put on a flat table. Make sure the appliance
is unplugged and the power is off.
2) Remove the water guard and rinse it using clean water. Use a wet and
clean cloth with some water to wipe the inside of water tank.
3) Pour 1 litre of clean water or (a mixture of 0.5 litre white vinegar and
0.5 litre clean water is preferable) into the water tank (the water level
should not reach beyond than the exhaust hole). Press both water taps
to ensure water flows out.
4) Connect the power plug to the power socket and switch on the
power switch located at the back panel of the dispenser.
5) Heat the water inside the water tank until the LED band turns green.
Thereafter turn off the power switch at the back panel, unplug the power
plug and wait for 15minutes.
6) After 15 minutes, pour out the water from the water tank. At the
bottom panel of the dispenser, remove the C-ring and open the drain
valve (near warning signage for hot water). Drain the water out of the
dispenser. Pour and drain out the dispenser (with the drain valve
removed) using clean water for about 1 minute.
7) Close the drain valve, install the C-ring back, put back on the flat
table, and assemble the water guard.
To Next Page
Loading...