(B) Install the water bottle
1) Remove the seal from the bottle cap.
2) Slowly place the bottle vertically into the water guard, and middle pole of water guard will pull
in the inner cap into bottle.
3) Before initial use, open hot water tap and room temperature tap to drain about 500ml water,
at the same time, inside air will be exhausted, out of appliance.
4) Connect the power plug to the power socket, and switch on the power switch on the back panel
of the dispenser.
5) Heat the water until the LED bands turns green. Open the hot water tap to drain the hot water
until the LED bands turns red. Open the room temperature water tap for 5-10seconds to drain
water out.
6) Repeat step no.5 above for one more time.
(C) Dispensing hot water and room temp water
1) When the LED band is red light, it means heating. When the LED band turns green light, it means
the hot water is ready to be dispensed.
2) Open the hot water tap to dispense hot water.
3) Open the room temp water tap to dispense room temp water.
To Next Page
Loading...