Sprout Immerse Speaker - Connecting Multiple Speakers via UNISYNC; Wireless Charging

POWER
Press the power buton for 3 seconds to turn the
Immerse on or of.
PLAY/PAUSE/ANSWER
Press the play/pause/answer buton to play or pause
songs and answer mobile phone calls.
VOLUME CONTROL
Shor press ‘-’ buton to decrease volume.
Shor press ‘+’ buton to increase volume.
TRACK CONTROL
Long press ‘-’ buton to select previous song.
Long press ‘+’ buton to select nex song.
BLUETOOTH
Press the Bluetooth buton to turn on/of the Immerse
Bluetooth function.
CONNECTING MULTIPLE SPEAKERS VIA
UNISYNC
TM
If you are using the UNISYNC feature you can
connect one Immerse as a primary, then connect up
to 50 UNISYNC devices as replicas.
To connect a replica, shor press the UNISYNC
buton on your primary device once to enter
UNISYNC mode. Once the primary announces it is
in UNISYNC mode, repeat on the replica. Afer the
replica announces it is in UNISYNC mode, press the
UNISYNC buton once more – the replica should now
announce it is using UNISYNC audio. The primary
speaker will show a solid blue light while replicas will
show a flashing red and blue light.
Press UNISYNC buton again to disable UNISYNC.*
Press and hold the UNISYNC buton for five seconds
to reset the UNISYNC function.**
*If UNISYNC is disabled, Immerse will disconnect from but
remember the replicas connected to it.
**Reseting UNISYNC will enable Immerse to ‘forget’ all replica
devices.
WIRELESS CHARGING
The wireless charging pads conveniently recharge
your Qi-compatible devices.
4. OPERATING CONTROLS 4. OPERATING CONTROLS
76