TURNING SOUNDWAVE PRO ON/OFF
To power on, long press the power buton for 2
seconds. Soundwave Pro will announce “power on”
whilst the LED indicator light at the top will light up.
It will flash blue/red until a Bluetooth connection
has been established.
To power of, long press the power buton for 2
seconds. The speaker will announce “power of”
with the LED indicator also turning of.
To preserve batery, Soundwave Pro will
automatically turn of afer 5 minutes of no Bluetooth
or 3.5mm aux connection.
CONNECTING VIA 3.5MM AUX CABLE
To play audio using the aux cable, connect the cable
from the Soundwave Pro to your device. The LED
indicator light will change to a solid red. Soundwave Pro
will play the audio when you press ‘play’ on your device.
Please note: Using 3.5mm aux input will override a
Bluetooth source input.
CONNECTING VIA BLUETOOTH
1. Press the power buton for approximately two
seconds. The LED indicator light will flash blue and
red to indicate Soundwave Pro is ready for pairing*
2. Turn on Bluetooth on your mobile phone/
music device**
3. ’Soundwave Pro’ will appear on your mobile
phone/music device. Select ‘Soundwave Pro’
to pair
4. Once your mobile phone/music device is
connected to the Soundwave Pro speaker,
the LED indicator light will change to a solid
blue, and the speaker will announce “Bluetooth
connected”***
5. Enjoy your music
*Soundwave Pro will automatically enter Bluetooth pairing
mode when turned on for the first time. To reset Bluetooth
pairing, hold the UNISYNC buton for 6 seconds to forget all
devices and initiate Bluetooth pairing mode again.
**If you are not familiar with Bluetooth pairing for your mobile
phone or music device, refer to the user guide for your mobile
phone/music device for instructions to pair a new device
using Bluetooth.
***Soundwave Pro will always store the last device paired
and if the device is within Bluetooth range, Soundwave Pro
will automatically connect to the device.
3. QUICK START GUIDE 3. QUICK START GUIDE
54
To Next Page
Loading...
