Sprout SOUNDWAVE PRO - Operating Controls; Button and Indicator Functions

LED INDICATOR
• Flashing blue/red - Bluetooth pairing mode
• Solid blue - Bluetooth connected
• Solid red - 3.5mm aux connected
POWER BUTTON
• 2 second long press - power on/power of
• 4 second long press - power on + Bluetooth pairing
PLAY BUTTON
• 1 press - play/pause/answer call/end call
• 2 second long press - reject call
• 2 presses - Siri/Google
VOLUME UP BUTTON
• 1 press - volume up
• 2 second long press - nex track
VOLUME DOWN BUTTON
• 1 press - volume down
• 2 second long press - restar track
• 2 second long press x2 - previous track
UNISYNC
TM
BUTTON
• 1 press - cycle through UNISYNC functions
(UNISYNC mode/UNISYNC audio/UNISYNC disabled)
• 2 second long press - disconnects Bluetooth
(device remains paired to Soundwave Pro)
• 6 second long press - resets UNISYNC and Bluetooth
connection (device will need to be re-paired)
3. QUICK START GUIDE 4. OPERATING CONTROLS
CHARGING YOUR SOUNDWAVE PRO
1. Remove the por cover on the back of the
speaker, and connect the speaker via the USB-C
por to the USB-A power source, using the
included charging cable
2. The LED batery indicator will flash from one to four
LEDs to indicate Soundwave Pro is charging. The
lights will stop flashing once Soundwave Pro is fully
charged. A full charge will take approximately 4-5
hours, depending on the speed of the charger.
Once charged, remove the charge cable and
replace the por cover.
Please note: Soundwave Pro will announce
“low batery” when the batery level reaches
approximately 10%
LED BATTERY INDICATOR
4 white lights on: Batery 76-100%
3 white lights on: Batery 51-75%
2 white lights on: Batery 26-50%
1 white light on: Batery 0-25%
76