What to do if the power light does not come on for my SPT IM-120B Ice Maker?
If the power light on your SPT Ice Maker doesn't illuminate, first ensure the unit is properly plugged into the outlet. If it still doesn't turn on, the fuse on the PCB might be burnt and needs replacement.
Why is the 'ice full' indicator light on my SPT Ice Maker when the basket isn't full?
The 'ice full' indicator might be triggered on your SPT Ice Maker even if the basket isn't full due to several reasons. It could be that the room temperature is too low; try removing and replacing the ice basket. Alternatively, the sensor might be delayed if the ice basket was just emptied or ice dropped directly onto the sensor. Wait a couple of minutes for the sensor to pick up the correct temperature, or place your fingertips around the sensor to speed up the process. If neither of these resolves the issue, the sensor may be defective.
What to do if water low and ice full indicators flash simultaneously on my SPT IM-120B Ice Maker?
If the water low and ice full indicators are flashing simultaneously on your SPT Ice Maker, it could be due to ice cubes sticking together and not dropping from the evaporator. To resolve this, unplug the unit and transfer the ice in the bucket to another freezer. Wait for the ice to melt from the evaporator, then reconnect the power and restart the unit. It is also recommended to select a smaller ice size. If it doesn't help - synchronous motor may be detected.
How to fix a buzzing noise from the compressor of my SPT Ice Maker?
If the compressor of your SPT Ice Maker is making a buzzing noise, it could be due to low voltage. Turn off the ice maker, ensure the voltage is normal, and then restart it.
Follow safety notices to avoid fire, shock, or potential harm. Refer to electrical safety regulations.
Pay attention to warnings to avoid harm. Handle unit with care, ensure ventilation, and follow cleaning procedures.
Details the function of the START, STOP, and ICE SIZE buttons, along with the ICE FULL and LOW WATER indicators.
Instructions on how to move the unit without tilting it more than 45 degrees, using handles.
Place unit on a stable, flat surface with at least 6" clearance around the unit.
Connect to an independent wall socket with a tight connection. Unplug when not in use or before cleaning.
Procedure for removing ice cubes from the storage basket.
Steps for filling the water tank, ensuring not to exceed the MAX water level.
Procedure for draining water from the unit, including replacing the drain plug.
To Next Page
General
