SPT SZB-20 - User Manual

Questions and Answers

R
renee02Jul 28, 2025
What to do if the 'WATER LOW' light is on in my SPT Ice Maker?
- J
  Justin SantosJul 28, 2025
  If the 'WATER LOW' indicator light is on, it suggests there may be a problem with the water supply. Possible causes include: * A water shortage from the main supply. Ensure that the water supply is connected and functioning correctly. * A damaged water valve. Inspect the water valve for any signs of damage. * Low water pressure. Make sure that the water pressure is higher than 1.5 bar.
S
santospatriciaAug 3, 2025
Why is my SPT SZB-20 compressor working but not making ice?
- J
  Jeremy Anthony MDAug 3, 2025
  If your SPT ice maker's compressor is running but no ice is being produced, consider these possibilities: * There could be a refrigerant leak. Contact refrigerator repair shops to recharge the refrigerant. * The refrigeration system may be blocked. Check if the ventilation fan is working properly.
N
Nicholas WeaverAug 9, 2025
What does it mean when the 'FAULT' light is on in my SPT Ice Maker?
- R
  Robert MorrisAug 9, 2025
  If the “FAULT” indicator light stays on, it means that flake ice motor or fan motor is damaged. Contact Sunpentown.
B
blakehernandezAug 14, 2025
What does it mean when the 'ICE FULL' light is flashing on my SPT Ice Maker?
- A
  andrew67Aug 14, 2025
  If the 'ICE FULL' indicator light is flashing on your SPT ice maker, the ice full sensor may be loose or damaged. Replace the ice full sensor.
A
Andrew DonovanAug 20, 2025
What does it mean when the 'FAULT' and 'WATER LOW' lights flash and the 'RUN' light is solid on my SPT SZB-20?
- G
  Glen GarciaAug 20, 2025
  If the “FAULT” and “WATER LOW” lights flash and the “RUN” light stays solid, the unit is overheated. The internal temperature is above 164°F. The unit will resume operation when the internal temperature drops below 158°F.