11
Note the sag percentage where the o-ring
stopped.
If your target sag percentage is not
achieved, spring preload adjustment and/or
coil spring replacement must be performed.
Coil spring preload in RockShox® dual
crown forks is an internal adjustment that
compresses or decompresses the spring
without initiating travel.
The coil spring can be preloaded with up to
five internal preload spacers.
Remove preload spacers to decrease
preload and increase sag.
Install preload spacers to increase preload
and decrease sag.
Spring preload can be used to fine tune sag,
but preload does not change coil spring rate
and is not a substitute for the proper coil
spring rate.
If your target sag cannot be achieved with
the maximum of five preload spacers,
replace the coil spring with a firmer spring.
If your target sag cannot be achieved with
zero preload spacers, replace the coil spring
with a softer spring.
Repeat the sag process until your target sag
percentage is achieved.
<10%
>30%
AdjustMeasure Install
To Next Page
Loading...
