Page 5
ASSEMBLY (CONTINUED)
Before plugging in the controller, ensure that both the heater activation button as well as the side
mounted on/off switch are not currently engaged. This will prevent accidental dry ring.
Off Position
- Button is not recessed
- No indicator light
On Position
- Button is recessed
- Red indicator light
Side Mounted “ON/OFF” Switch in “OFF” Position
Always verify the element is fully submerged in water before activating the heater element. Dry
ring the element will cause irreversible damage to the element coil and void the element’s
warranty. Prolonged dry ring can cause damage to the vessel and other components, and can
result in personal injury or property damage.
Make sure that the unit is connected to a dedicated GFCI circuit.
Wear proper PPE (Personal Protective Equipment) when using the equipment. This would
include protective eyewear, gloves and apparel that would aid in prevention of scalding from
boiling water.
WARNING
ACTIVATION BUTTON
O
F
F
O
N
O
F
F
O
N
To Next Page
Loading...
