St. Croix 400 - User Manual

1
400/488 Rotating Davit
Installation Instructions
These instructions were written with the owner in mind. If you are the installer make sure these
instructions are passed along to the owner of the boat. Please read through the entire instructions before
beginning the installation.
TERMINOLOGY
DAVIT ARM (400/488) – One pair of davit arms
will carry an inflatable that weighs no more than
350,/488 lbs. gross weight, respectively. That
includes the boat, motor, gas tank and
miscellaneous items you will leave in the
inflatable.
HEAD OF THE ARM – The end of the davit
with the white plastic wheels.
BALL JOINT – Lower mount.
CLAM SHELL – Upper mount
CLEAT – Found on the top of the davit arm.
Used to secure lifting lines.
PULLEY (BLOCK) – The lower pulley is a
four-sheave pulley.
BECKET – A horseshoe shaped piece of metal
attached to the pulley (block). Used to attach a
lifting sling or a hook when using the St. Croix
Lifting Yoke.
TOOLS REQUIRED FOR INSTALLATION:
 7/16” Wrench
 7/16” Socket
 3/8 Electric Drill (slow or variable speed)
 ¼” Drill Bit and 5/32 Drill Bit
 5/32” Drill Bit (not a cheap one)
 Hand operated Rivet Gun (you should have one, this is a neat tool, don’t buy the cheap
one).
 Level
 Tape Measure
 Fresh Coffee & Soft Music

St. Croix 400 Specifications