13. The ON/OFF light blinks under certain conditions. Does this mean anything?
a. The ON/OFF light blinking will mean one of two things.
When the stove is first started and the stove is in the
“Start-up” program, the light blinks until the “Proof of
Fire” switch locks in. This indicates the “Normal
Operation” and the light stays on constantly.
b. If the stove is running on a Thermostat it will start up as
described in point (a), but during “Normal Operation”
when the Thermostat is not calling for heat the stove
drops to the #1 setting and “Pilots” until the thermostat
calls for heat again. The LED light indicating the Heat
Level will not drop to the #1 setting during “Pilot
Mode”. During this time the ON/OFF light will be
blinking, indicating that the stove is in “Pilot Mode”.
14. The ON/OFF light is always blinking and the stove only runs on with a low fire, even
though I have the Heat Level on #5.
This usually indicates a problem in the Thermostat circuit. There is either a bad
connection in the wires or the Thermostat itself has a problem. Troubleshoot all of the
components in the system.
If the stove is not operating on a Thermostat, check the small jumper wire between the
Red and Black connectors of the Thermostat wire Terminal on the back of the stove.
(See page 20 of the Installations Manual, Thermostat Hook-up)
These questions and answers will usually solve most problems that you run into during
the break in period of the stove or if a component fails in the stove. Before calling your
dealer for assistance, please read your
Operations Manual and perform all the
maintenance issues covered in the
Daily and Periodic Maintenance section of the
Manual. If the stove still does not operate correctly call your Dealer for Assistance.
24
Lancaster Operations & Maintenance Manual
To Next Page
Loading...
