b. Pressing the auger trim button again will turn
on the #1 and #4 light at the same time. This
will decrease the feed rate by .25 seconds.
This is the
#1-Low setting, 1.25 seconds. The #1 Low setting will
give less heat, but will also cause more build-up to form on the
glass.
11.
What does the Draft Trim Button do? This button will rarely be
used. In the event the stove is connected with a chimney system
that has a strong Natural Draft, this button will allow the draft on
the low (#1) feed setting to be adjusted, by reducing the voltages
to the combustion fan.
The control board must be on the #1
setting to see the LED lights flashing.
By pressing the button the
first time, the voltage will be reduced 5-8 volts. All LED lights
will flash
once. Pressing the button a second time will reduce the
voltage another 5-8 volts. The LED lights will flash
twice,
indicating the second adjustment. Pressing the button a third time
will return the control board to the default setting, and the LED
lights will flash once.
Remember: Any of the above mentioned adjustments to the
#1 setting on the control board will be lost if the unit gets
unplugged or if there is a Power Failure.
23
Lancaster Operations & Maintenance Manual
To Next Page
Loading...
