!
Specifications
• Voltage: AC100V～240V, 50-60Hz
• Power Consumption: 80W
• Light source: 7x 10W RGBW 4 in 1 LED
• Beam angle: 25°
• Max output @1m: 6100 Lux
• PAN 540°, Tilt 270° with 16bit control
• DMX channels: 7 or 12 DMX Channels
• Packing Dimensions: 210x210x140mm
• Net weight: 2,75 Kg
Fe atures
• 3PIN XLR DMX in and out
• IEC power in and out
• 4 control modes: DMX512, automatic programs, sound control, mast/slave
• LCD display for easy setup
• Indoor operation temperature range: -20°C～+40°C
• Dimmer: 0-100%
• Strobe 0-10Hz
Please Note: Specifications and improvements in the design of this unit and this
manual are subject to change without any prior written notice.
2. INSTAL L ATION
Installation requirements
• The product can be hung or placed on a solid surface
• If you install the light in a hanging position, always use a suitable mounting
position and a clamp or screw that is strong enough to hold the product
without stress. Always use a safety wire to secure the light.
• Always keep a distance of minimum 0.5m to all objects or persons
• Installation should always be done by a trained professional.
• Make sure the light always has good ventilation
• It is recommended to always use 110 Ohm DMX cable to prevent data
corruption of your DMX control signal
To Next Page
