Automatic mode
With the menu button, select the automatic mode (Auto) and press the enter key to
confirm. In this mode, the fixture will play a variety of in-built effects at various
speeds.
Set Menu
With the menu button, select the “Set” menu and press the enter key to confirm.
Then use the enter key ton enter the “remo” menu. You can now use up and down
buttons to activate (on) or deactivate (off) the infra-red system used for the remote
control.
Colour Mode
With the menu button, select the Colour mode (CoLr) and press the enter key to
confirm. Then use the up and down buttons to select the desired colour. Red (rxxx),
Green (gxxx), blue (bxxx), white (Uxxx) and Yellow (Yxxx) and press the enter key to
confirm. Then use the up and down buttons to increase or decrease the colour
amount (from 001 to 255). Press enter to confirm.
Thanks to this colour mixing mode, you can virtually choose all the desired fixed
colours.
You have now access to the pre-programmed colours menu (CCxx). Press enter and
use the up and down button to select it. Press enter to confirm.
The last menu of the colour mode is the strobe function (STxx). Press enter and use
the up and down button to select the desired strobe speed from St00 to St99.
Slave mode
With the menu button, select the slave mode (SLAv) and press the enter key to
confirm. In this mode, the fixture will automatically follow the other BAT34’s present
in the same daisy chain (See “Connections” section). At least one of the BAT32 in
the chain needs to be in another mode.
To Next Page
Loading...
