Stahlwille SmartCheck - Page 4

Establishing the current supply .................................................... 21
Operation
..................................................................................... 25
Operating module ........................................................................ 25
Switching the DPG on .................................................................. 26
Setting the mode .......................................................................... 27
Setting the torque unit .................................................................. 28
Setting the target torque .............................................................. 29
Setting the torque target zone ..................................................... 30
Resetting the display ................................................................... 32
Resetting the display prior to direction changes .......................... 33
Overload warning ......................................................................... 33
Switching the DPG off .................................................................. 34
Testing torque wrenches
............................................................. 35
Connecting a torque wrench to the DPG ..................................... 35
General measurement of torques ................................................ 37
Testing indicating torque wrenches ............................................. 38
Testing click type torque wrenches ............................................. 39
Eliminating faults or malfunctions
.............................................. 41
Cleaning
....................................................................................... 43
Calibrating the DPG
..................................................................... 43
Disposal
....................................................................................... 44
EU declaration of conformity
...................................................... 45